Lumatek 400W digital ballasts are dimmable and produce consistent stable light output which is ideal for pharmaceutical agriculture, controlled-environment horticulture and other uses where precise regulated output is essential.
Lumatek ballasts are microprocessor-controlled and feature intelligent start with sequential switching to light lamp faster with safe management of inrush current and balanced load across ring circuit to avoid tripping breakers. When dimming or boosting lamp the ballast uses ’soft dim feature’ to change power output gradually to protect lamp.
This ballast is small and compact in design, operates silently with no noisy fan and only weighs 2.5Kg making it easy to handle and mount.
Lumatek 400W digital ballast is extremely efficient producing very little heat and for safety uses full circuit protection including open/short circuit, over temperature, over/low voltage, end of lamp life/rectification and EMI suppression.
Lumatek use the best quality electronics components and our design ensures longer lamp life with minimum PAR/PPF output loss over time and is dramatically less than traditional magnetic ballasts. Lumatek ballasts light both HPS and MH lamps (please note that Super Lumens (SL) switch cannot be engaged for MH lamps).
Four power-output settings at 250W, 250SL, 400W & 400SL. Boost power by 10% by selecting SL settings.
- Voltage: 230V 50/60Hz
- Input Current Max (A): 1.90A
- Input power: 440W
- Output power: 420W
- Power factor: >0.99
- Voltage range: 175 to 275V
- THD: <8%
- Lamp CCF: <1.7
- Operating frequency: high frequency
- Envirement temperature for full load operation: -25 to 40°C (-13 to 104°F)
- Enclosure temp. rise ((Δt): 29°C (84.2°F)
- Env.IP require: >IP23
- Humidity: capable of operating in relative humidity of 0% to 90%, non-condensing
- Weight: 2.5Kg
- Dimensions: 230 x 114 x 81mm
Electronic ballast for 250W or 400W HPS or MH lamp
No audible noise, no flicker
Full circuit protection; open/short, over temperature, over/low voltage, end of lamp life/rectification
EMI suppression certified
To light a 250W lamp; set control to 250W and boost output by 10% by switching to 250SL.
To light a 400W lamp; set control to 400W and boost output by 10% by switching to 400SL or dim down to 250SL or 250W.